亚洲一区欧美在线,日韩欧美视频免费观看,色戒的三场床戏分别是在几段,欧美日韩国产在线人成

圓弧刃刀具微細非自由切削參數建模與預
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


and Prediction of Non-free-cutting Parameters on Micro-cutting with Rounded-edge Tool
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    非自由切削是影響微細切削加工的重要效應之一。針對微細切削條件下刀具圓弧刃區切削干涉作用顯著增強的特點，通過單元刀具之間切削干涉對切屑流動方向的影響分析，建立了圓弧刃刀具的排屑方向干涉模型。應用Stabler法則和最小能量耗散原理確定出圓弧刃刀具作縱向進給的切屑流動方向、等效切削刃、流屑角和非自由系數。選取不同進給量和切削深度的組合對以上非自由切削特征參數進行了數值預報，預報結果可用于微細切削非自由狀態的評價和改善，以及切削用量的合理匹配。

    Abstract:

    Non-free-cutting is an effect which affects the mechanism of micro cutting greatly. The influence of cutting intervene between elementary cutting tool on chip flow direction was analyzed, and chip flow intervene of the rounded-edge tool was mathematically modeled aims at the increase of cutting intervene caused by chip flow in the rounded-edge of micro cutting tool. Furthermore, chip flow direction, equivalent cutting edge and chip flow angle were deduced with Stabler rule and minimal energy dispersion principle respectively. Those above parameters were numerical predicted under different feed rate and cutting depth, and the prediction results can be used for the evaluation and improvement of micro-cutting status, as well as the optimization of cutting regimes.

    參考文獻
    相似文獻
    引證文獻
引用本文

劉志兵,王西彬,方澤平.圓弧刃刀具微細非自由切削參數建模與預[J].農業機械學報,2010,41(3):204-208. and Prediction of Non-free-cutting Parameters on Micro-cutting with Rounded-edge Tool[J]. Transactions of the Chinese Society for Agricultural Machinery,2010,41(3):204-208.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: